Maintenance; Wearing Parts; Service; Product Disposal - Zeiss Stemi 305 cam Instrucciones De Manejo

Stereo microscope
Stemi 305 cam
5.2

Maintenance

5.2.1

Wearing parts

The following wearing parts can be ordered directly from ZEISS:
Description
Plastic plate B/W, d = 84 mm
Glass plate, d = 84 mm
Eyecups
Eyepiece 10x/23
Set of small components
consisting of:
- 2x spiral cables RJ-12
- 1x cable RJ-12 , length 1m
- 2x caps, eyepiece
- 1x cap, microscope body
- 1x Allen key, SW 3
- 1x M6 clamping screw, microscope mount
- 2x M6 clamping screws for C mount
- 2x rubber rings, eyepiece
- 1x Cover, C-mount Stemi 305 trino
- 2x Dust cover for eyepiece tubes
- 1x M4x8 screw
Protective dust cover, stand K
5.3

Service

All interventions in mechanical, optical and electronic internal microscope components may only be
performed by Carl Zeiss Service or by specifically authorized qualified staff.
To ensure your microscope is optimally set and also operates correctly over an extended period of time,
we recommend that you conclude a service/maintenance contract with ZEISS.
For reordering or in case of service, contact your nearest regional ZEISS representative.
5.4

Product disposal

The product was developed, tested and produced in accordance with the valid regulations and guidelines
for environmental law of the European Union.
The product and its accessories comply with the EU-regulations 2011/65/EC (RoHS) and 2012/19/EC
(WEEE), and the German Electrical and Electronic Equipment Act (ElektroG).
The product contains electronic components which must be disposed of according to the requirements of
the 2002/19/EC WEEE Directive and not as domestic waste. In addition, the national regulations must be
complied with.
For details on disposal and recycling please refer to your relevant ZEISS sales or service organization.
03/2015
CARE, MAINTENANCE AND SERVICE
Maintenance
Order No.
435425-9320-000
435425-9310-000
444801-0000-000
415500-1800-000
435063-9044-008
Remark
required 2x
ZEISS
23