Zeiss Stemi 305 cam Instrucciones De Manejo página 6

ZEISS
The visualized images of the Stemi 305 cam body with Wi-Fi may only be used for professional
training and research. These images are not meant to be used for direct generation of
diagnostic results.
Never cover the open light guide socket or the fibre optic output. There is a fire hazard!
In all cases avoid covering the open light guide socket or the fibre optic output with your hand
or other parts of your body. There is a risk of burns!
Safe disconnection from the power supply is ensured exclusively by removing the mains plug.
The switch on the microscope only switches into standby mode.
Do not replace detachable mains cables by inadequately designed mains cables. Only the
specified power supply lines may be used.
The microscope and the Controller K LED each feature a desktop power supply which permits
changing the voltage setting on the instrument.
The desktop power unit meets the requirements of protection class II (with protective
insulation). If its casing is damaged, put the power unit out of operation. The microscope may
only be operated with the desktop power unit supplied with the instrument.
Changing the lamps on the cold light source is only admissible in accordance with the
manufacturer's operating manual. If the appropriate instructions are not complied with, there is
a risk of burns and explosion when changing the lamp.
Defective devices should not be disposed of with household waste; dispose of them in
compliance with the statutory provisions.
Samples must also be disposed of appropriately in accordance with the applicable statutory
provisions and internal work instructions.
The stereo microscope Stemi 305 cam incl. its original accessories may only be used for the
applications described in this operating manual. The manufacturer cannot assume any liability
for other applications, including those of individual modules or single components.
Changes to and maintenance on this device and on devices which are operated together with
the microscope may only be performed by our service or by authorized persons. The
manufacturer of the devices does not accept any liability for damage due to unauthorized
interventions in the device. Moreover, such interventions invalidate all guarantee / warranty
claims.
4
INTRODUCTION
Notes on Device Safety
435063-9044-008
Stereo microscope
Stemi 305 cam
03/2015