ZEISS
Fig. 7
Adhesive label on the back of the
device
At choice, the mode "Connection to existing WLAN" can be used for camera control.
The Stemi 305 cam body with Wi-Fi may only be used if it is covered by a radio license for your
region. Contact your ZEISS representative.
The visualized images of the Stemi 305 cam body with Wi-Fi may only be used for professional
training and research. These images are not intended to be used for direct generation of
diagnostic results.
4.1.1
Mode "WLAN Access-Point" (factory setting)
In this mode, each Stemi 305 cam provides its own WLAN.
In the WLAN settings of the iPad, all Stemi 305 WLAN networks are recognized which are within reach.
After establishing the connection to one of these WLAN networks, the connected Stemi 305 cam appears
as an icon in the Apps Labscope / Matscope and can be controlled via the iPad. Change-over to another
Stemi 305 cam is only possible if the user changes over to the WLAN of the required Stemi 305 cam in
the WLAN settings of the iPad.
Depending on the WLAN and on the image contents, between 3 and max. 6 iPads can be connected to
the WLAN of a Stemi 305 cam, thus being used for viewing live images, for camera control or snapshots.
Due to the delayed live stream and the line loss thus caused, it is not recommended to use more than 6
live streams.
To operate several Stemi 305 cams comfortably (without changing the WLAN network), each
Stemi 305 cam disposes of another operating mode, i.e. the mode "Connection to existing
WLAN" which can be set via a WLAN configuration website.
18
OPERATION OF THE INTEGRATED CAMERA WITH WI-FI
Commissioning the camera
435063-9044-008
•
The adhesive label on the back of the micro-
scope body (Fig. 7) shows the WLAN identifier
(SSID) set by the factory, and the WLAN
password of the device. SSID and WLAN
password can be changed subsequently via a
WLAN configuration website.
SSID:
WLAN password:
Stereo microscope
Stemi 305 cam
Stemi-xxyyzz
ZEISS1846 [...]
03/2015