Clock; Manually Set Clock; Temperature And Humidity; Ice Warning - Oregon Scientific Weather@Home Thermo Plus Manual De Usuario

CLOCK

MANUALLY SET CLOCK

1. Press and hold MODE for 2 seconds to enter the
setting mode.
2. The settings order is: 12/24 hour format, hour,
minute, year, calendar format (day-month / month-
day), month, day and language.
3. Press or to change the settings.
4. Press MODE to confirm.
The language options are English (E), German (D),
French (F), Italian (I), and Spanish (S).
To select display mode:
Toggle MODE to choose among clock with seconds /
clock with weekday / calendar.

TEMPERATURE AND HUMIDITY

To select temperature unit:
1. Open the battery compartment.
2. Select °C or °F for temperature readings by a pin
or the top of a pen.
3. Close the battery door.
To select an outdoor sensor's reading:
• Toggle or to select your desired sensor channel.
RAR213HGX-Manual-EN-R8.indd 6
To auto-scan among sensors:
1. Press and hold and MEM at a time for 2
seconds to enable auto-scan function for all 5
channels. The temperature will be displayed
automatically in sequential order for 3 seconds
each.
2. To end, press or
To display current, minimum and maximum
records of the day from a selected sensor:
• Toggle MEM.
To clear the records:
• Press and hold MEM for 2 seconds.
NOTE The record will also be cleared once the
batteries are removed from the main unit.

ICE WARNING

If the channel 1 sensor falls from 37°F to 28°F (3°C
to -2°C), LED indicator
will stop flashing once the temperature is out of this
range.
• To disable the ice alert warning, press
the same time.
• The ice warning detection will restart once the
temperature falls out of 37°F to 28°F (3°C to -2°C),
and will then trigger the flash again when the
temperature falls into this range.
6
.
will flash, and
and at
2018/8/15 上午10:24