Sensor Data Transmission; Temperature; Ice Warning; Reset - Oregon Scientific Weather@Home EMR211X Manual De Usuario

NOTE Use alkaline batteries for longer usage and consumer
grade lithium batteries in temperatures below freezing.

SENSOR DATA TRANSMISSION

To search for a sensor:
1. Press or to select among 5 different outdoor
channels of remote sensors.
2. Press and hold
researching for the selected sensor.
To auto-scan among sensors:
• Press and hold for 2 seconds to enable auto-scan
function for all 5 channels. The temperatures will be
displayed automatically in sequential order (Channel
1,2,3,4,5)
The sensor reception icon at the front of the main
unit shows the status:
ICON
EMR211X_M_EU_EN_R7.indd 4
for 2 seconds to enforce
DESCRIPTION
Main unit is searching for
sensor(s).
A channel has been found.
The sensor cannot be found.
TIP The transmission range may vary depending on
many factors. You may need to place the sensor(s) in
different locations to get the best result(s).

TEMPERATURE

To select temperature unit:
• Press SET to select °C or °F for temperature readings.

ICE WARNING

If the channel 1 sensor falls from 37°F
to 28°F (3°C to -2°C), LED indicator in the front of the
main unit will flash continuously, and will stop flashing
once the temperature is out of this range.
• Press and at the same time to deactivate the
ice alert warning.
• The ice alert warning will be disable/enable again
when the temperature falls again from 37°F to 28°F
(3°C to -2°C).
NOTE As ice alert is only applicable to channel 1, to
prevent flashing of LED, select channel 2-5 on outdoor sensor.

RESET

Press RESET at the rear of the main unit to return to
the default settings.
4
2018/8/15 下午4:29