Connect Ac Adapter; Remote Sensor; Sensor Data Transmission - Oregon Scientific BAR208SX Manual Del Usuario

LOCATION
Clock / alarm and Indoor
temperature area
Outdoor temperature area

CONNECT AC ADAPTER

Connect the supplied power adapter to the power jack, then
plug into a standard AC outlet.
NOTE
•
The batteries are only for back-up use. Always connect
the unit to the power grid source via AC/DC adapter.
• Make sure the adapter is not obstructed and is easily
accessible to the unit.
• The base station and adapter should not be exposed to
wet conditions. No objects filled with liquid, such as vases,
should be placed on the base station and adapter.
• To completely disconnect from power, unplug adapter
from the mains.

REMOTE SENSOR

The main unit can collect data from up to 3 sensors.
To set up the sensor:
1. Open the battery compartment (see FIG 3).
2. Select a channel then press RESET.
3. Close the battery door.
4. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount.
MEANING
Main unit batteries low
Sensor batteries low
4
TIP Ideal placements for the sensor would be in any location
on the exterior of the home at a height of not more than 5 ft
and which can shield it from direct sunlight or wet conditions
for an accurate reading.
150cm(5ft)
NOTE Use alkaline batteries for longer usage and consumer
grade lithium batteries in temperatures below freezing.

SENSOR DATA TRANSMISSION

To search for a sensor:
Press and hold + MODE.
The sensor reception icon in the remote sensor area shows
the status: