Remote Sensor; Sensor Data Transmission - Oregon Scientific BAR208HG Manual De Usuario

LOCATION
Clock / alarm and
Indoor temperature area
Outdoor temperature area

REMOTE SENSOR

The main unit can collect data from up to 3 sensors.
To set up the sensor:
1. Open the battery compartment (see FIG 3).
2. Select a channel then press RESET.
3. Close the battery door.
4. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount.
TIP Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than 1.5 m (5 ft) and which can shield it from direct
sunlight or wet conditions for an accurate reading.
BAR208HG_M_EN_R3.indd 4
All manuals and user guides at all-guides.com
MEANING
Main unit batteries low
Sensor batteries low
1.5m(5ft)
NOTE Use alkaline batteries for longer usage and
consumer grade lithium batteries in temperatures below
freezing.

SENSOR DATA TRANSMISSION

To search for a sensor:
Press and hold
The sensor reception icon in the remote sensor area
shows the status:
4
+ MODE.
8/9/07 9:14:04 A