Sensor Data Transmission; Clock; Clock Reception; Reception Signal - Oregon Scientific BAR386 Manual De Usuario

SENSOR DATA TRANSMISSION

The sensor reception icon in the remote sensor area
shows the status.
ICON
and "- - . -"
(Outdoor
temperature area)
To search for a sensor:
Simultaneously, press and hold MEM and CHANNEL
for 2 seconds.
NOTE If the sensor is still not found, check the batteries,
obstructions, and remote unit location.

CLOCK

CLOCK RECEPTION

This product is designed to synchronize its date and time
automatically once it is within range of:
• DCF-77 generated from Frankfurt, Germany for Central
Europe.
• MSF-60 generated from Rugby, England.
DESCRIPTION
Main unit is searching
for the sensor(s)
A channel has been found
and sensor signal is being
received
The sensor cannot be found.
Search for the sensor or check
batteries
The clock collects the radio signals whenever it is within
1500 km (932 miles) of a signal.
NOTE Slide the EU / UK switch to appropriate position for
your location. Repeat each time you reset the unit.
NOTE Initial reception takes 2-10 minutes for first set up
or when RESET is pressed. Once complete, the reception
icon will stop blinking. If the signal is weak, it can take up
to 24 hours to get a valid signal.

RECEPTION SIGNAL

Clock signal reception indicator:
STRONG SIGNAL
To enable and force a signal search:
Press and hold for 2 seconds.
To disable the signal reception:
Press and hold for 2 seconds.

SET CLOCK

If the clock signal reception is enabled and a signal is being
received the clock does not need to be manually set.
1. Press and hold MODE for 2 seconds.
2. Press or to change the settings.
6
WEAK SIGNAL NO SIGNAL