Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GRANDE BRIO RIDE ON 75
OPERATING MANUAL
V01
11 WEEKLY MAINTENANCE
11.1 Replacing the rear floor-wiper rubber
Proceed as follows to change the drying edge of the rear floor-wiper rubber if it is worn and does not dry properly:
1. Remove the floor-wiper.
2. Open the blade hook and unscrew the lock handwheels (Fig. 2)
3. Pull out the rubber-pressing blade and the rubber (Fig. 2)
4. Turn the rubber over or replace it as necessary (Fig. 2)
5. Reassemble by performing these procedures in reverse order
Adjust the height of the floor-wiper depending on the rubber (see Adjusting the heicht of the floor wiper support)
11.2 Replacing the front floor-wiper rubber
Aspiration is poor and the machine will not dry perfectly if the front floor-wiper rubber is worn. Proceed as follows to
replace:
1. Detach the floor-wiper from the machine.
2. Loosen the screws that clamp the front rubber
3. Pull out the rubber-pressing blade and the rubber (Fig. 2)
4. Turn the rubber over or replace it as necessary
5. Reassemble by performing these procedures in reverse order
11.3 Cleaning the aspiration hose
If aspiration is insufficient check that the aspiration tube is not clogged. Clean as necessary with a jet of water, spraying
in from where it is inserted in the tank. Proceed as follows to do this:
1. Detach the aspiration tube from the cover on the recovery tank from the steel spring and from the
floor-wiper;
2. Clean it with a jet of water, spraying from the part where it is inserted into the tank
3. Reassemble everything by repeating these procedures in reverse order
11.4 Cleaning the recovery tank
Proceede following the indications in chapter "10.1 Cleaning the recovery tank
Technological Systems by Moro S.r.l. (T.S.M. S.r.l.)
Via F.lli Zambon,9 - 33080 Z.I. Praturlone - Fiume Veneto (PN) – ITALY
Tel.: +39 0434 564167; Fax: +39 0434 954069
Mail:
info@tsmitaly.com
- Website :
www.tsmitaly.com
22
Publicidad
Tabla de contenido
