Tools Required - Hella 2PT 008362-801 Instrucciones De Montaje

Tools required:

Preparation:
10
Page 4/5:
Assembly
1. Screw open housing.
2. Insert rubber grommet into lamp
housing from inside (lubricate
with soap if necessary)
• Ruler
• Phillips screwdriver
• Combination pliers
Mounting is possible upright of
pendant above or below the bumper.
Lamps should not vibrate or extend
beyond bonnet and should be
attached symmetrically.
•Determine mounting position and
mark mounting points in accor-
dance with attachment dimensions
specified above.
•Drill pilot hole with 3 mm bit and
drill out to 6.5 mm. Seal drilled
metal parts with rust protection
agent.
3. Insert cables (brown and yellow)
through rubber grommet from
outside to inside, cut to length
and fasten with cable straps.
Strip insulation off of ends, crimp
on terminals (small) and connect.
4. Break out pre-marked point for
condensate drain at bottom of
housing.
• Open end or box wrench, 10 mm
• Drill with 3 mm and 6.5 mm dia.
bits
min.
600 mm*
* Min. 400 mm on vehicles with
widths < 1300 mm.
5. Screw lamp housing and reflector
back together.
6. Screw mounting bracket onto
vehicle.
7. Screw lamps onto mounting
brackets and align horizontally.
max.
1500
min.
mm
250
mm