Bulb Replacement - Hella FF40 Instrucciones De Montaje

Mounting steps:
Page 4, 5
With regard to the mounting height,
there are no special regulations for
the lights.
It is possible to mount the lights
in an upright or pendant position.
The lights must not vibrate or jut
out above the bonnet, and must be
mounted symmetrically. Determine
the mounting position and mark the
fastening points. Drill using a 3 mm
drill bit, and drill out to 8.5 mm.
Seal drilled metal parts with rust
11
protection. When fi tting the lights,
Ensure that the „TOP" marking
on the housing always points up-
wards. Light points upwards. Align
Electrical connection:
From page 6
fi t the relay with the connection
terminals pointing downwards in a
waterproof manner. If required and
if legally permitted, fi t a switch in
the dashboard.
the light in accordance with the
drawing and tighten the screws.
Lay and connect the cables in ac-
cordance with the circuit diagram.
According to circuit diagram
the auxiliary lights are switched
on together with the existing spot-
lights. According to circuit diagram
II , the auxiliary lights are swit-
ched on in addition to the existing
headlights via a separate switch.
It is however essential that coun-
try-specifi c laws are observed.
Check the lighting system, fasten
the connection cables securely.
Have the spotlights adjusted at a
specialist garage.
Only correctly adjusted lights
provide optimum light.

Bulb replacement:

I ,
Page 7
Replace bulb in accordance with
the drawing. Do not touch bulbs
with bare fi ngers! Use a paper
towel or similar.