Quick Start - ECOVACS ROBOTICS DEEBOT D35 Manual De Instrucciones

3.2 Quick Start

1 Charging Dock Placement
Place the Charging Dock on a level floor
surface against the wall with the base
perpendicular to the ground. Keep the
immediate area 1.5m (5') in front of the charger
and 0.5m (1.6') on both sides of the charger
clear of objects and reflective surfaces.
Plug the Charging Dock in.
Install Side Brushes
2 2
A t t a c h S i d e B r u s h e s t o t h e b o t t o m o f
DEEBOT 3 by pressing a brush into each slot
until it clicks.
Power ON
3
Turn the robot's Bottom Power Switch to
the ON position. " " indicates ON and " "
indicates OFF.
When DEEBOT 3 is not working, it is suggested
*
to keep it powered ON and charging instead of
powered OFF.
Charge DEEBOT 3
4
Place DEEBOT 3 on the Charging Dock making
sure the Charging Contacts on DEEBOT 3 and
the Charging Dock Pins make a connection.
Charge DEEBOT 3 for at least 12 hours
before the first use.
Indicator Light blinks when DEEBOT 3 is
*
charging, and stays on when D35 is fully
charged.
3. Operating and Programming
7
EN