Led Indicators; Supported Vehicle Interfaces - Bosch MTS 6517 VCI Manual Original

4.10.3

LED Indicators

Four Light Emitting Diodes (LEDs), are located on the
front of the MTS 6517 VCI. The LED indicators provide
the following status information.
LED Symbol LED Function
Vehicle Communication
Error Indicator
PC Host Communication
Power On
4.11

Supported Vehicle Interfaces

The following sections list the vehicle communication
interfaces supported by the MTS 6517 VCI.
4.11.1 Serial Data Interfaces
The MTS 6517 VCI supports the following Serial Data
Interfaces.
CAN
R
3 Independent CAN Controllers (up to 1 Mbps)
R
3 two Wire (High Speed CAN transceivers (ISO-
R
11898-2)
R
ISO-15765 -2,4
R
ISO-15765 -3 (ISO 1429901, UDS on CAN)
R
ISO-14230 (KWP2000 on CAN)
R
GM LAN
R
J1939
R
Low-Speed, Fault-Tolerant CAN Transceiver (ISO-
R
11898-3)
R
J2190
R
Single Wire CAN Transceiver (J2411)
J1850
R
SAE J1850 VPW
R
SAE J2850 PWM
Robert Bosch GmbH
UART
R
2 Independent UART's (software selectable pins)
R
2 K/L – Line Transceivers (12Vor 24V) connected to
any pin pair
R
KWP2000
R
KW 81,82
R
KW1281
R
ISO 9141-1,-2
R
Ford UBP
R
Fiat auf 9141
R
Honda 92
R
J2190 auf 9141
R
J2190 auf KWP
R
J2610
R
J1587 auf J1708
R
J1708
R
Chrysler SCI
R
Chrysler CCD
R
DS2
R
Nissan DD
R
Mitsubishi High-Side Driver
R
KW309
R
SDL
R
Repeat Messaging
R
KW71
R
Device Config
R
B-CAN
R
Honda UDS
R
Honda WEN
R
95Hm Carb
R
H99
R
H99B
R
Diag H
R
UBP
R
1 (5 Volt) UART Transceiver (GM UART protocol)
connected to any pin pair
4.11.2 Non-Serial Data Interfaces
The MTS 6517 VCI supports the following Non-Serial
Data Interfaces.
R
Pin Voltage Measurement for all DLC Pins
R
Programmable Voltage Generator (5-20 Volts) for
ECU reprogramming
| MTS 6517 VCI | 25 en
|
1699200092 B 2017-06-20