Metal Cutting - DeWalt DC330 Manual De Instrucciones

Sierra de vaivén inalámbrica de 18 v para trabajo pesado
Ocultar thumbs Ver también para DC330:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

METAL CUTTING

In cutting thin gauge sheet metals, it is best to clamp wood to the
bottom of sheet metal; this will insure a clean cut without the risk of
vibration or tearing of metal. Always remember to use a finer blade
for ferrous metals (for those that have a high iron content); and use a
coarser blade for non-ferrous metals (those that do not have an iron
content). Use a high speed setting for cutting soft metals (aluminum,
copper, brass, mild steel, galvanized. pipe, conduit sheet metal, etc.).
Use lower speed to cut plastics, tile, laminate, hard metals, and cast
iron.
MAINTENANCE
WARNING: To reduce the risk of injury, turn unit off
and disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do not
use water or any cleaning solutions.
Accessories
WARNING: Since accessories, other than those offered by
D
WALT, have not been tested with this product, use of such
E
accessories with this tool could be hazardous. To reduce the risk of
injury, only D
WALT recommended accessories should be used with
E
this product.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you
need assistance in locating any accessory, please contact D
Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286,
call 1-800-4-D
WALT (1-800-433-9258) or visit our website: www.
E
dewalt.com.
NOTE: The DW3311 flush cutting blade is for use with D
DW331, DC330, DC308 and DC318 jig saws only.
Repairs
The charger and battery pack are not serviceable.
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by a D
WALT factory service center, a D
E
authorized service center or other qualified service personnel. Always
use identical replacement parts.
15
WALT
E
WALT
E
WALT
E

Publicidad

Tabla de contenido
loading

Tabla de contenido