Maintenance - Sima HALCON 65 Manual De Instrucciones Original

 Always use Individual Protection Equipment (IPE) in accordance with the type of work you
are effectuating.
 Prohibit strangers to access the place of work of the machine.
 Work clothes are not supposed to have loose articles that can cling into movable parts of
the machine.
 When moving the machine, always do so with the engine stopped.
 To use gasoline-powered machines, the workplace should always be well ventilated
because the combustion gases emitted by the exhaust are toxic.
 Take care not to touch especially engine exhaust with the machine in operation as it
reaches high temperatures can be maintained for several minutes after shutdown.
 Note also the safety recommendations by the engine manufacturer in his book of
instructions.
SIMA, S.A. is not responsible for the consequences possibly generated but the inadequate use
of the HALCON power trowel model.

5. MAINTENANCE

Maintenance operations should be performed by people who know the machine and its
functioning.
The most basic are summarized below and some recommendations for implementation:
 Any machine handling should be done with the engine stopped and, if electrically
powered machines, the power cord must be disconnected.
 Always consider the safety recommendations mentioned in this manual as well as
appearing on the engine.
 Do not use pressurized water to clean circuits and electrical components.
 If the machine is not covered, cover it with waterproof material.
 Check the gearbox oil level through the viewfinder.
 ATTENTION: the partial or total lack of oil in the gearboxes causes premature
wear of its component parts. The oil to use in the gearbox must meet the
following characteristics: Designation ISO VG 320 and CLP-320 according to
DIN 51502. If necessary replace oil, remove the filler cap located on the left side of the
gearbox and fill to complete the recommended oil level with good quality and specific for
treat bronze elements, for example, those listed below:
 For gasoline engines, control the level of engine oil by placing the machine in a
horizontal surface. Engines mounted on the HALCON Power Trowel, are alarmed by low
oil level, so that when the level falls below the minimum the engine will stop and does
not start until you have added enough oil. Use oil SAE 15W-40
Necessary maintenance operations on the engine are described in its own book of
instructions, and the frequency with which to perform them. It is necessary to comply
with all maintenance operations specified in the instruction books of the
engine.
 Clean the machine as often as necessary, as the normal working process leads to an
accumulation of dust and concrete. If water pressure is used careful not to direct it to
the engine.
FABRICANTE
FUCHS RENOLIN -----------------------------MP 320
CASTROL---------------------------------------ALFHA SP 320
BP-----------------------------------------------GRXP 320
MOBIL------------------------------------------MOBILGEAR 632
SHELL-------------------------------------------OMALA-320
REPSOL-----------------------------------------SUPERTAURO 320
(Petrol
REFERENCIA
engine).