Setting The Hdmi Setup; Hdmi; Cec Control; Setting The Surround Parameter Setup - Sherwood R-807 Instrucciones De Funcionamiento

Setting the HDMI Setup

HDmI

You can specifies the routing of the HDMI audio signal
from the system or through to a TV or flat screen TV.
The HDMI connection can carry uncompressed digital
video signals and digital audio signals. Depending on
whether the digital audio signals input into the HDMI
IN are output from the HDMI MONITOR OUT of the
main unit or not, you should set the HDMI Audio Output
correctly.
menu item Description
Disables HDMI digital audio
signals output from the HDMI
MONITOR OUT of this main unit.
AmP
Then, these signals are heard
from the speakers connected to
this receiver.
Enables HDMI digital audio signals
output from the HDMI MONITOR
TV
OUT of the main unit. Then,
these signals are heard from the
speakers of your TV.
Note
• If the HDMI Audio Output is set to "TV", no sound
will be heard from the speakers connected to this
receiver (except ROOM 2 speakers) even if an
input source is selected.

CEC Control

The CEC Control function allows input selection of the
main unit to be interlocked with the operation of the
connected components.
menu item Description
On Enables the CEC Control function.
Off Disables the CEC Control function.
Setting the Surround
Parameter Setup

Height Gain

You can adjust the front height channel level as desired
(This setting is valid only when listening in Dolby Pro
Logic IIz mode).
menu item Description
Decreases the front height
l : low
channel level.
Outputs the front height channel
m : mid sound with standard sound volume
level.
Increases the front height channel
H : High
level.

PANORAmA

You can extend the front stereo image to include the
surround speakers for an exciting effect with side wall
imaging.
menu item Description
On Enables the panorama effect.
Off Disables the panorama effect.

Center Width

This adjusts the center image so it may be heard only
from the center speaker, only from the left or right
speakers as a phantom image, or from all three front
speakers to varying degrees. The control can be set in
8 steps from 0 to 7.

Dimension

This function gradually adjusts the sound field either
towards the front or towards the rear.
The control can be set in 7 steps from -3 to +3.

Center Image

When one of the Neo:6 is enabled, you can adjust
the level of the center image so it may be heard from
the center speaker more The level can be adjusted in
11 steps from 1 to 10.
Customizing Settings
47