Speaker Setup; Speaker Crossover; Speaker Distance; Speaker Channel Level - Sherwood R-807 Instrucciones De Funcionamiento

R-807 NETWORk AV RECEIVER

Speaker Setup

There are several ways you can use the speaker
channels with the main unit. In addition to a normal
home theater setup where they are used for the front
height speakers, they can be used as an independent
speaker system in another room.
• Select the desired speaker, and then press  to
enter its setting menu.
menu item
Selects the desired item
Yes/No depending on whether the
speakers are connected or not.
Selects the desired item
2 Channel/ depending on the number of
1 Channel (left) speakers connected to Surround
Back/Multi channels.
Note
• When a speaker is not set to "NO", you need
to set their distances from listening position
and crossover frequencies according to their
frequency characteristics. For details, see
"Speaker Crossover" on page 46 and "Speaker
Distance" on page 46.
• When the "SR" is set to "NO", "SB" cannot be set
to "2 Channel" or "1 Channel (Left)".
• When the surround back channels' power
amplifier is assigned to "Room 2", the "SB"
cannot be selected. For details, see "AMP
Assign" on page 44.

Speaker Crossover

You can set the crossover frequency according to the
frequency characteristics of the connected speakers.
For details on the frequency characteristics, refer to the
operating instructions of the speakers.
• You can select the crossover frequency among Full
Range, 40 Hz, 60 Hz, 80 Hz, 100 Hz, 120 Hz, 150 Hz,
200 Hz, and 250 Hz. The default setting is 100 Hz.
• Select "Full Range" when the selected speaker can
fully reproduce frequencies below 40 Hz.
Note
• You cannot select the subwoofer and the speaker
set to "NO".
• If the frequency range of your speaker is
100 Hz~20 kHz, the crossover frequency should
be set to 100 Hz or slightly higher. For details,
refer to the operating instructions of the speakers
to be connected.
• Frequencies below the crossover frequency are
output from the subwoofer or the speakers when
they are set to "Full Range" (when not using a
subwoofer).
46

Speaker Distance

• Select the desired unit (Meter or Feet) before setting
• You can set the distance within the range of 0.1 ~
• About the speaker distance
Description

Speaker Channel level

You can adjust the current channel levels as desired.
After adjusting each channel level with the test tone,
adjust the channel levels either according to the program
sources or to suit your tastes. For details, see "Adjusting
each channel level with test tone" on page 30.
the speaker distance. Once a unit is selected, the
distances are automatically converted to the selected
unit.
9.0 meters in 0.1 meter intervals (or 0.5 ~ 30.0 feet
in 0.5 foot intervals).
When enjoying multi-channel surround playback with
sources such as Dolby Digital and DTS sources, etc.,
it is ideal that the center, surround, and surround
back speakers should be the same distance from
the main listening position as the front speakers.
By entering the distance between the listening
position and each speaker, the delay times of center,
surround and surround back speakers, etc. are
automatically adjusted to create an ideal listening
environment virtually as if they were in their ideal
locations.