Preliminary Operations; Description Of The Automation System Components Layout; System Electrical Connection - VDS PH Instrucciones Para La Instalación

Preliminary operations

2. DESCRIPTION OF THE AUTOMATION SYSTEM
2.0 COMPONENTS LAYOUT
Flashing warning/courtesy lamp (to be positioned
A -
at a point clearly visible from both approaches)
B - Safety photocell
C - Manual key-operated control unit (magnetic, digital,
keyboard combination lock, mechanical, etc.)
Microprocessor control unit in watertight container
D -
(if possible, to be fi tted in a position sheltered from
atmospheric agents)
F - Watertight operator electricity supply junction box
(recommended), to be positioned so that cables are not
subject to dangerous stretching during the gate motion
2.1

SYSTEM ELECTRICAL CONNECTION

- When making the electrical connections,carefully follow the instructions for each of the components, referring
to the wiring diagram D1.
!
Warning
• Make the electrical connection of the single components after having completed their installation.
• The entire circuit must be made consistent with the current safety regulations.
• Use cables with a cross-section of 1.5 mm
• Protect the operator power cable with a sheath if necessary; do this before connecting the cable to the
junction boxes.
!
Warning
• Every operator comes complete with a pickup capacitor. During installation, connect the capacitor to
the electrical equipment according to the wiring diagram supplied.
- After making the electrical connections, check the thrust force at the end of the gate leaf; if necessary, adjust
the pressure of the operator according to the procedure described in the specifi c paragraph.
1
D1
3
9
2 for the wiring.
2
7
8
6A
0,030 A
G - Antenna
H - Aprimatic PH series operators
I - Electric lock (optional)
L - Open position gate stop
M - Close position gate stop
N - Ground connection for metal framework
Information
Consult the price-list for additional (optional) safety
devices.
5
1 Antenna
6
2 Flashing lamp
3 Receiver photocell
9
4
4 Transmitter photocell
5 Internal control panel
6 Key control
7 Electrical lock
8 Electronic control unit
9 Junction box
- 16 -