Rear Operator Mounting - Special Cases - VDS PH Instrucciones Para La Instalación

Installation
Caution
• The size of the plates must be proportioned to the
size of the columns.
• If the A-type plate is used and has to be positioned
in line with the operator axis, the hook fi ttings
must be modifi ed as shown in fi g. C7.
Clean out any traces of cement or sand.
Drill four holes (C8 pos. 1), after marking the position of
the holes, using the anchorage plate itself as a drilling
guide mask.
Attach the plate with "FISCHER" expansion anchors of
minimum ø 15 with M8 steel or cast iron screws (C8 pos.
2) (if the material the column is made of is able to hold
the screws), or, if not, attach with glue as follows:
- Insert the mesh sheaths (C8 pos. 3) into the holes
and inject the quick-dry glue (C8 pos. 4); see attached
instructions for application method and quantity.
If the B-type plate is used:
- Insert the stud bolts (C8 pos. 5) into the sheaths (if
the B-type plate is used).
- Fit the anchoring plate (C8 pos. 7) to the stud bolts.
If, on the contrary, the C-type plate is used:
- Insert the stud bolts (C8 pos. 5) into one of the two
sides of the inset.
- Fit the anchoring plate (C8 pos. 7) to the stud bolts.
- Insert the two remaining stud bolts (C8 pos. 8).
At this point, if plates B or C are used, screw in all the
fi ttings, nuts and washers by hand, without tightening;
after about half an hour tight
wrench.
When fi nished, cut off the protruding parts of the stud
bolts using the correct tool.

4.1.4 Rear operator mounting - special cases

For outward-opening gate leaves, the rear mounting has
to modifi ed using an L-plate as shown in
C9
For dimensions A,B and C
consult table C1
en up the stud bolts with a setscrew
(C9).
Inside entrance
C6
Y
C7
C8
RECOMMENDED GLUE FITTING
(other glue fitting systems
are available on the market)
Type B plate
Type C plate
C8
PRESSURE FITTING
Type B plate
- 20 -
max. from hinge axis
to plate edge
Type C plate