Assembling The Changer; Attaching The Changer; Using The Convertible Playmat - Evenflo BabySuite Manual De Instructiones

A B
Connect an elbow tube to the straight tube . Make sure they snap together securely with an audible click. Pull the tubes to make sure they are securely attached to each other.
C
Insert the end of tube assembly into a corner opening on the changer
C
Push the tube assembly completely through the changer until it comes out of the other opening, as shown.
E
Connect the other elbow tube to the tube assembly
4

ATTACHING THE CHANGER

upward.
Note: Tubes are pre-installed on the bassinet and require only to be To avoid serious injury or death:
connected.• Check to ensure bassinet is fully secure by firmly pressing down on all four Connect one set of tubes
sure they are securely connected. Repeat for the other set of • DO NOT use bassinet with children over 15 lbs (6.8 kg). Discontinue use tubes.when child begins to push up on hands and knees or can roll over.
D
, as shown.
C
. Make sure they snap together securely with an audible click. Pull the tubes to make sure they are securely attached.
D E
and together, as shown. Make corners of the mattress pad.
• FALL HAZARD: To prevent falls, do not use this product when infant begins to push up on hands and knees or has reached
manufacturer's recommended maximum weight, whichever comes first.
A
To use the mattress pad with the bassinet, place it on the bassinet, cushion side up. Push down firmly on the mattress to
attach the Velcro straps.
J
Insert the six mattress straps on the mattress pad through the slots
the underside of the bassinet. Make sure all six straps are properly secured to the bassinet. Note: The mattress pad must
always be used with the Velcro tabs facing downward to secure the pad to the floor of the bassinet.
WARNING
K
in the bassinet and fasten them to the Velcro tabs on

ASSEMBLING THE CHANGER

USING THE CONVERTIBLE PLAYMAT

5