Assembling The Exersaucer - Evenflo BABY ACTIVE exer saucer 61912186 Manual Del Usuario

Warnings - continued
WARNING
READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS!
FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY OR DEATH!
• Only batteries of the same or equivalent type, as recommended, are to be used.
• DO NOT dispose of batteries in fire, as batteries may explode or leak.
• The supply terminals are not to be short-circuited.
• DO NOT use rechargeable batteries.
• DO NOT recharge non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toys before being charged.
• Rechargeable batteries are to be charged under adult supervision.
• Promptly remove exhausted batteries from the toy.
• Remove batteries before storing unit for a prolonged period of time.
• DO NOT allow unit to get wet.
• Dispose of used batteries properly.

Assembling the ExerSaucer

A
C
CLICK!
1. Holding Foot , as shown, press slanted end of Leg
C
audible click. Press slanted end of Leg
to create the Leg Assembly. Repeat these steps for the other two Leg Assemblies.
Note: If Leg does not Click in place, and can be removed, it is the incorrect leg for that
side. Try the other hole in the Foot.
D
2. Insert both metal tabs on Leg Cap
B
A
CLICK!
into Foot until you hear an
A C
into Foot until you hear an audible click,
B C
E
into opening on top of Tray
E D
2
E > !
3. Insert first metal plate
shown and push tab out of the way to install. Rest second metal plate flat against tray
slots.
E > @
make sure they are securely attached.
B
E
C
A
4. Slide Leg
you hear an audible click. Then slide Leg
opening in bottom of Leg Cap
steps for the other two Leg Caps
E
E
D
E > #
.
E > @
into the first retainer slot on the underside of the Tray
E > !
Repeat for other two Leg Caps .Once plates are inserted pull on them to
E
CLICK!
B
from lower leg assembly into opening in bottom of Leg Cap
A
B
until you hear an audible click. Repeat these
E
.
E
For future storage:
To remove Leg Caps
on bottom of Leg Cap and pull legs out.
3
Assembling the ExerSaucer
D
until
E
from lower leg assembly into other
, press tabs
E E > #
, as