MRA 4025066147328 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
2 Neoprene rings
2 Neoprene sealing washers
2 Locking nuts, M5
2 Oval head screws, M5 x 16 mm
2 Oval head screws, M5 x 25 mm
4 Plastic washers
Fitting the screen to the motorcycle:
1. Stand your motorbike up on a level surface.
2. Remove the original mounting screws, and the screen by pulling it out towards the
rear (P1).
3. Remove the front rubber nuts from the screen and insert them into the two holes in
the front of the MRA screen (P2).
NOTE: You will have to reinsert the washers into the rubber nuts.
4. Place the MRA screen into the fairing and fasten it using the M5 x 16 mm oval head
screws, and tighten the screws up. Use the M5 x 25 mm oval head screws to fasten
the rear of the screen.
5. Place the 4 mm rubber washer between the fairing and MRA screen, and the
neoprene ring underneath the fairing (P3).
6. Place the metal/neoprene washer onto the screw from underneath with the
neoprene side against the fairing. Finally, turn the locking nut just far enough onto the
screw for it to lie flush with the end of the screw.
Make sure that you do not overtighten the screws.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
BMW K1200S / K1300S [XCT]
Article No..
--- Torx 25 screwdriver
10634 8 mm box spanner
3 mm Allen key
10634
10994
10554
10641
10635
3
Required tools