Fit The Receiver Collar - Petsafe HDT11-13911 Instrucciones De Uso Y Manual De Adiestramiento

To Turn the Receiver Collar On and Off
Using the Test Light Tool or a coin, turn the battery module until the on ( | ) symbol or off ( O ) symbol
aligns with the triangle symbol on the Receiver Collar Note: To extend the life of the batteries, turn the
Receiver Collar off when it is not in use.
Important: If the Receiver Collar is left on continuously, the maximum battery life will be 10 days.
Receiver Collar LED – Function and Response
Receiver Collar Function
Turn unit on
Any Remote button pressed
Low battery condition
Step 3

Fit the Receiver Collar

Important: The proper fit and placement of your Receiver Collar is important for effective operation.
The Contact Points must have direct contact with your dog's skin on the underside of his neck.
To assure a proper fit, please follow these steps:
1. Make sure that the Receiver Collar is turned off.
2. Start with your dog standing comfortably (3A).
3. Place the Receiver Collar on your dog's neck close to the ears. Center the
Contact Points underneath your dog's neck, touching the skin (3B). Note: It is
sometimes necessary to trim the hair around the Contact Points to make sure that
contact is consistent.
Do not shave the pet's neck as this may
increase the risk of skin irritation.
10
LED Response
LED flashes 1 time and beeps
On for length of button press
LED flashes 3 times every 5 seconds
Customer Care Center 1-800-732-2677
3A
3B