Enabling The Alarm - Silvercrest WE-2100 Manual Del Usuario

Multi-band tuner WE-2100

Enabling the Alarm

After the desired alarm time has been set, you can enable the
alarm as follows:
While the device is powered off, press the AL ON/OFF
button [8]. The alarm icon will show on the display [2].
To disable the alarm, press the AL ON/OFF button [8] again.
The alarm icon will disappear from the display [2].
The device will power on at the set alarm time and will
receive the last tuned-in frequency and frequency band.
To power the device off, first press the AL ON/OFF button
[8] twice. The alarm icon will disappear from the display [2].
After this, the Off button is unlocked and can be pressed
again.
Press and hold the Off button [6] until the device powers off.
68 - English
You have successfully disabled the alarm. To
use the alarm once again, you must enable it
again.
Even when the alarm function is enabled, you
can use the device as usual. However, please
note that the device powers on using the last
tuned-in frequency, frequency band and volume.
Also bear in mind that you must power the
device off for the alarm (auto power-on) to work
properly.