Faber PRETTY ISOLA ACT Manual De Instrucciones página 10

Fixing the Frame/Chimney
Should it be necessary to adjust the height of
the frame, proceed as follows:
• Unfasten the metric screws joining the two
opposite parts that can be seen from the
front;
• Adjust the height of the frame as required,
then replace the screws removed as above,
making sure that you insert 2 of them close
to the panel lock;
• Lift the frame, insert the slots onto the
screws and slide them until they lock;
• Tighten the two screws and insert the other
two screws provided.
• Take the telescopic chimney locking
bracket 7.2, remove the film from the dou-
ble sided adhesive and fix it inside the
frame so as to hold it more firmly.
Before final locking of the screws it is possi-
ble to make small adjustments to the frame,
making sure that the screws do not come out
of the adjustment slot.
• The Frame must be securely fastened both
due to the weight of the Hood and the stress
caused by occasional sideways pressure on
the Appliance when in position. When fas-
tened, check that the base is stable even
when the Frame is subjected to bending.
• In all cases where the Ceiling is not suffi-
ciently strong at the point of suspension,
the Installation technician must strengthen
it with suitable plates and counterplates,
anchored to structurally sound elements.
EN
1
2
1
2
1
10