Faber PRETTY ISOLA ACT Manual De Instrucciones página 14

AFTER COMPLETING INSTALLATION AND CONNECTION TO THE POWER SUPPLY THE SYSTEM
• According to the type of Hood Commands, press and hold button
- In the former case the Display will show the letters An followed by CA;
- In the latter case an animation will be displayed.
• Calibration of the system takes 40 seconds, during which "noises" will be heard.
WARNING:
After calibrating the system, test all the hood functions (see paragraph on USE).
• If during use the "Active Noise" system does not work properly and makes strange noises,
contact the Service Department immediately.
• The hood can still be used by Disabling the "Active Noise" system.
• Turn the hood off if it is on.
• According to the type of Hood Commands, press and hold button
- In the former case the Display will show the letters An followed by dS to indicate that the
system has been Disabled;
- In the latter case only light-up of certain symbols will be displayed;
• After finding a solution to the problem it is possible to Reactivate the "Active Noise"
system by pressing and holding the same buttons for 5 seconds.
- In the former case the Display will show the letters An followed by En to indicate that the
system has been Enabled;
- In the latter case all the symbols will be displayed switched off;
EN
Calibrating the "Active Noise" System
MUST BE CALIBRATED.
Possible Anomalies in the "Active Noise" system
or for 5 seconds,
or for 5 seconds.
1
14