Control Panel - Faber PRETTY ISOLA ACT Manual De Instrucciones

USE
A
Button Function
A Turns the suction motor on and off at speed one.
B Decreases the working speed.
C Increases the working speed.
Press and hold for approximately 5 seconds, with all the
other loads off (Motor+Lights) to activate calibration of
the "Active Noise" system (lasts 40 seconds).
D Activates Intensive speed from any other speed, includ-
ing motor off. This speed is set to operate for 6 minutes,
after which the system returns to the speed that was set
before. Suitable to deal with maximum levels of cooking
fumes.
E 24H function
Turns the motor on at speed one and effects one 10 min-
ute extraction every hour.
When the filters alarm is triggered, the alarm can be
reset by pressing and holding this button for approxi-
mately 3 seconds.
These indications are only visible when the motor is
turned off.
F Delay function
Activate automatic switch-off with a 30' delay. Suitable
to complete elimination of residual odours. It can be
activated from any position and is deactivated by press-
ing the button or turning the motor off.
Press and hold the button for approximately 5 seconds,
with all the loads turned off (Motor and Lights), to turn
the Remote control on/off.
G Turns the lighting system on and off at maximum inten-
sity.
H Turns the lighting system on and off in Courtesy Light
mode.
Press and hold the button for 5 seconds to Disable / En-
able the electronic "Active Noise" system.
EN
B C D

Control panel

E F
Display
Displays the set speed
Displays the set speed
Displays the set speed
Displays An and then CA.
Displays HI and the time remaining alternately, once a
second.
Displays 24 and the dot at the bottom right flashes
once a second, while the motor is running.
It is disabled by pressing the button.
FF flashes three times.
When the procedure terminates, the indication shown
previously turns off:
FG indicates the need to wash the metal grease filters.
The alarm is triggered after the Hood has been in op-
eration for 100 working hours.
Displays the operating speed and the dot at the bottom
right flashes once a second.
IR+Dot (Flashes twice)-Alarm Activated.
IR+Dot (Flashes once)-Alarm Deactivated.
Displays An and then dS – "Active Noise" system
Disabled
Displays An and then En – "Active Noise" system
Enabled
G H
1
15