Cleaning And Maintenance; Cleaning Side Brushes - cecotec CONGA 1490 Manual De Instrucciones

base when it runs out of battery. Choose between its 3 scrubbing power levels: high,
medium or low.
• Do not use the mop outdoors.
• Remove the carpets before operating the robot under this mode.
• During operation, control the water level on the Wet&dry tank. If it empties, fill it up
again before continuing scrubbing.
• Take the Wet&dry tank and the mop out before charging the robot.
Note: in order to ensure perfect scrubbing, moisten the mop before starting scrubbing.
7. Gyro mode: When this mode is activated, the robot will carry out a whole cleaning cycle
in Gyro mode and then in Edge mode. Once it has finished, it will automatically return to
the charging base. If it has not started the cleaning cycle from the charging base, it will
return to the starting point.
Note: If the room being cleaned is smaller than 10 m2, the robot will carry out the same cycle
twice.
8. Manual mode: Use the direction buttons on the App display to take the robot to the
specific points where you want it to clean.
9. Back home mode: This mode can be selected at any point of any cleaning cycle. Once it is
activated, the robot will automatically return to the chargin base. If the robot has run out
of battery, it will return to the charging base with the LED indicator in red, if it returns with
battery, the LED light will be lit in blue.

5. CLEANING AND MAINTENANCE

CLEANING SIDE BRUSHES

• Make sure the side brushes are in good conditions.
• If the bristles are deformed, introduce the side brush into water.
• Clean them regularly in order to keep them in good conditions.
CLEANING WET & DRY TANK AND FILTERS
• Empty and clean the Wet & dry tank after each use.
• Wash the primary filter each 15-30 days to lengthen their service life.
• Dry completely the filters before placing them back in their position.
• Do not expose the filters to direct sunlight.
• The maximum service life of the primary and High-efficiency filter is 6 months.
ENGLISH
29