Viewing Videos; Turn On The Power - JVC DLA-X900R Manual De Instrucciones

Viewing Videos

LAMP
STANDBY/ON
3
2
INPUT
PHOTO
MEMO
WARNING
When you are using Q, be sure to remove the lens cover.
0
Connect the power cord, and ensure that the "STANDBY/ON" indicator
0
lights up in red.

Turn on the power

1
Remote control: press the C [ON] button
Projector unit: press the A [STANDBY/ON] button
The "STANDBY/ON" indicator light switches from red to green (light
0
goes off after the unit starts up).
1
(S R) The motorized lens cover opens.
0
"STANDBY/ON" lights up (red)
In standby state
STANDBY/ON TANDBY ND
.
Choose the image to project
2
Pressing the [INPUT] button on the projector unit or remote control each
time switches the input mode as follows.
Play back the selected device to project the image.
0
To hide the image temporarily
Press the [HIDE] button on the projector unit or remote control
The "STANDBY/ON" indicator light starts to blink in green.
0
Press the [HIDE] button again to resume display of the image.
0
The power cannot be turned off when the image is temporarily hidden.
0
"STANDBY/ON" lights up (green)
LAMP WARNING STANDBY/ON
HDMI 1
HDMI 2
.
During lamp startup
TANDBY ND LAMP WARNING
25