Information; Remote Code; Lamp Reset - JVC DLA-X900R Manual De Instrucciones

Glossary of Network Terminology
DHCP
IP Address
Subnet Mask
Default Gateway
MAC Address

Remote Code

For changing the remote control code.
You need to configure the remote control according to the settings of this unit.
0
On the remote control unit, press the [MENU] and [BACK] buttons at the same time for three seconds or longer to
switch the code.
The backlight of the remote control blinks 3 times: change the remote control code to "A"
0
The backlight of the remote control blinks 2 times: change the remote control code to "B"
0
Setting
A
B

Lamp Reset

For resetting the lamp time to "0".
Æ "Resetting the Lamp Time" （p. 63）

Information

Setting
Input
Source
(Displayed only during video signal input)
Resolution
(Displayed only during PC signal input)
H Frequency
(Displayed only during PC signal input)
V Frequency
(Displayed only during PC signal input)
Deep Color
Color Space
Lamp Time
Soft Ver.
PS Ver.
60
: Abbreviation for Dynamic Host Configuration Protocol. This is a protocol for the network
to assign an IP address automatically to the connected device.
: Numeric characters for identifying the device that is connected to the network.
: Numeric characters that define the bit count used for the network address that is a
segment of the IP address.
: Server for communicating beyond the network that is divided by the subnet mask.
: Abbreviation for Media Access Control address. This is a number that is unique to each
network adapter. Each of the network adapters is assigned with a unique MAC address.
Change the remote control code from "B" to "A".
Change the remote control code from "A" to "B".
Displays video input terminal.
Displays the input source.
Displays the image resolution.
Displays the horizontal frequency.
Displays the vertical frequency.
Displays the color bit depth of the input video signal.
Not displayed when YCbCr(4:2:2) is input.
0
Displayed when Deep Color information is received from the source device.
0
Displays the color space of the input signal.
Displays the lamp time.
Displays the firmware version.
Displays the version of image quality data.
Description
Description