Installation/Operation/Parts
For further operating,
installation, or maintenance
assistance:
Call 1-800-365-6832
English ....................... Pages 2-7
© 2014 Pentair Ltd. All Rights Reserved.
Safety Im portant Safety
Instructions
SAVE THESE INSTRUCTIONS - This manual contains
important instructions that should be followed during
installation, operation, and maintenance of the product.
This is the safety alert symbol. When you see this symbol
on your pump or in this manual, look for
one of the following signal words and be alert to the
potential for personal injury! indicates a hazard which, if
not avoided,
will result in death or serious injury. indicates a hazard
which, if not avoided,
could result in death or serious injury. indicates a
hazard which, if not avoided,
could result in minor or moderate injury.
NOTICE addresses practices not related to personal
injury.
Carefully read and follow all safety instructions in this
manual and on pump.
Keep safety labels in good condition. Replace missing or
damaged safety labels. California Proposition 65
Warning
This product contains chemicals known to
the State of California to cause cancer or birth defects or
other reproductive harm.
1. Know the pump application, limitations, and potential
hazards.
2. Do not use in water with fish present. If any oil leaks
out of the motor it can kill fish.
3. Disconnect power before servicing.
4. Release all pressure within system before servicing any
component.
5. Drain all water from system before servicing.
6. Secure discharge line before starting pump. An
unsecured discharge line will whip, possibly causing
personal injury and/or property damage.
7. Check hoses for weak or worn condition before each
use, making certain that all connections are secure.
For parts or assistance, call Flotec Customer Service at
Installation/Fonctionnement/Pièces
Pour plus de renseignements
concernant l'utilisation, l'installation
ou l'entretien,
Composer le 1 (800) 365-6832
Français ................. Pages 8-12
8. Periodically inspect sump, pump and system
components. Keep free of debris and foreign objects.
Perform routine maintenance as required.
9. Provide means of pressure relief for pumps whose
discharge line can be shut-off or obstructed.
10. Personal Safety:
a. Wear safety glasses at all times when working with
b. Keep work area clean, uncluttered and properly
c. Keep visitors at a safe distance from work area.
d. Make workshop child-proof – with padlocks, master
11. When wiring an electrically driven pump, follow all
electrical and safety codes that apply.
12. This equipment is only for use on 115 volt (single
phase) and is equipped with an approved 3-conductor
cord and 3-prong, grounding-type plug.
This pump has not been investigated for use in swimming
pool areas. Pump is supplied with a grounding conductor
and grounding-type attachment plug. Be sure it is
connected only to a properly grounded grounding-type
receptacle.
Where a 2-prong wall receptacle is encountered, it must be
replaced with properly grounded 3-prong receptacle
installed in accordance with codes and ordinances that
apply.
13. All wiring should be performed by a qualified
electrician.
14. Make certain power source conforms to requirements
of your equipment.
15. Protect electrical cord from sharp objects, hot
surfaces, oil, and chemicals. Avoid kinking cord.
Replace or repair damaged or worn cords
immediately.
16. Do not touch an operating motor. Modern motors can
operate at high temperatures.
17. Do not handle pump or pump motor with wet hands or
when standing on wet or damp surface, or in water.
kill. If your basement has water or moisture on floor,
Instalación/Operación/Piezas
Para mayor información sobre el
funcionamiento, instalación o
mantenimiento de la bomba:
Llame al 1-800-365-6832
Español .................Paginas 13-
19
pumps.
lighted – replace all unused tools and equipment.
switches, and by removing starter keys.
Risk of electric shock. Can shock, burn or kill.
Risk of electric shock. Can shock, burn or
1-800-365-6832
2
FP973 (05/09/14)