Installation Advice - Simu CENTRIS Serie Manual Del Usuario

3.3 - Tube preparation for motors with clamping jaws fixing
 &  : Power supply and
declutching cables.
 &  : Motor fixation
3.4 - Installation of motors with clamping jaws fixing (steps 1 to 5)
4
Passage of cables (all Centris range)

Installation advice :

- Remove any burr and sharp edges from the tube to avoid damage to cables.
- Exit the disengagement cable in the motor alignment.
- The cables should not obstruct the rolling up of the curtain.
- Allow sufficient curvature radii (150 mm minimum) in order to prevent any blockage.
- Declutching handle assembly: See instructions sheet delivered with the declutching handle kit.
- Minimun length of the declutching cable sheath in case of shortening:
0°
25°
0°
115°
0° 1 2
115°
Ø11 mm
2
1
2
1
3
4
2
4,5 m / Unrestricted
* **
0° 3 4
Ø11 mm
5
4
4
5
r = 150 mm min.
r
0°
25°
0°
25°
5
6 mm
24 N.m
±2
3
3
8 mm
30 N.m
±3
r
3/4