Inglesina Huggy Multifix Manual De Instrucciones página 22

HUGGY ISOFIX BASE
Install the Huggy Isofix base on board of the car referring to
the dedicated manual.
fig. 25 Install the Huggy Multifix car seat on the Huggy
Isofix base until hearing on both sides the CLICK signalling
the occurred hooking.
fig. 26 The correct hooking of the Huggy Multifix car seat
occurs when the proper indicators (I1) from RED become
GREEN. Make sure that the seat is properly hooked, trying to
lift it.
CAUTION: if the base Isofix connectors (I2) are not duly
hooked, the Inglesina Huggy car system does not allow
the correct installation of the Huggy Multifix car seat on
the base, as a consequence do not force the hooking.
fig. 27 After having hooked the Huggy Multifix car seat
on the base, press the two buttons (H2) simultaneously and
rotate the handle of the seat to the most forward position.
Make sure that the two buttons (H2) completely come out,
after having arranged the handle to the proper position.
fig. 28 Act on the release lever (I3) to release the first
blocking device of the car base. Then, push the base with
the seat against the car seat until it leans completely on the
same.
fig. 29 Verify once again that the Inglesina Huggy car
system is properly hooked.
REMOVAL OF THE HUGGY ISOFIX BASE
fig. 30 Rotate the seat handle to the vertical position and,
by acting on the rear lever (H7), lift it from the Huggy Isofix
base by holding it from the handle.
USE WITH INGLESINA EASY CLIP FRAMES
fig. 31 (COMFORT / OTUTTO / DOMINO frames).
For the correct use of the Inglesina Easy Clip frames, refer to
the dedicated manuals.
fig. 32 Properly open the frame, following the suitable
instructions. Holding the Huggy Multifix car seat by the
handle, place it on the frame on the central pin making sure
that the brakes are always properly engaged and that there
is not any carrycot or seat unit installed. Then, push the seat
unit downwards until hearing both CLICK sounds indicating
the occurred hooking.
CAUTION: always make sure that the seat unit is properly
hooked before use.
fig. 33 To remove the seat unit, act on the rear lever (H7)
and simultaneously lift it holding it by the handle.
USE WITH INGLESINA EASY CLIP STROLLERS
fig. 34 (ZIPPY STRIPTEASE/FREE – AVIO Strollers).
For the correct use of the Inglesina Easy Clip strollers, refer to
the dedicated manuals.
In the versions with removable seat unit, it is possible to hook
the seat unit directly on the frame, after having removed the
backrest properly.
Zippy ST/Free: remove the stabilizing supports and/or
armrest top covers, if any, following the suitable instructions.
Avio: hook the dedicated adapters, following the suitable
instructions.
fig. 35 Make sure that the brakes are properly engaged.
Holding the Huggy Multifix car seat by the handle, hook it
to the stroller on the central pin. Then, push the seat unit
downwards until hearing both CLICK sounds indicating the
occurred hooking.
CAUTION: always make sure that the seat unit is properly
hooked before use. Place the seat unit always facing the
mum.
fig. 36 To remove the seat unit, act on the rear lever (H7)
and simultaneously lift it holding it by the handle.
22 22