Wiring Diagrams - Ferroli JOLLY Plus 2 Serie Manual De Instalación

For all units with remote interface
Before closing the electrical box remember to carry out the connection to the remote interface according to the
specific instructions supplied .
Control TC PLUS Control TC PLUS
H2* water temperature probe 10 kΩ
AIR air temperature probe 10 kΩ
M1 fan motor DC inverter
S1 grill safety micro-switch
water solenoid valve (230V/50Hz 1A powered
Y1
output)
L-N 230V/50Hz electrical power supply connection
22
6

WIRING DIAGRAMS

INSTALLATION
BO
CH
CP
*
boiler go-ahead output (free contact max 1A)
chiller go-ahead output (free contact max 1A)
presence sensor input (if closed, the fan coil
goes into stand-by .)
If after powering the equipment the board
detects the probe, the start-up will take
place under normal conditions with minimum
water temperature in heating (30 °C) and
maximum water temperature in cooling (20
°C) functions .
The board can also operate without probe,
case in which the minimum and maximum
thresholds will be ignored .
Fig .1