HIKOKI PR-25B Instrucciones De Manejo página 8

English
Dø (mm) Code No.
25
29
32
35
38
45
54
64
79
94
105
○ Core bit shank
Code No. 955163
Applied to core bits above Dø 38 mm.
Code No. 956008
Applied to core bits below Dø 35 mm.
○ Center pin
Code No. 955165
Code No. 956009
for core bit Dø 32 mm and 35 mm
NOTE
Do not use it for core bit Dø 25 mm and 29 mm.
○ Drift key
(for self-drilling anchors)
(Code No. 944574)
○ Turning handle
(for self-drilling anchors)
(Code No. 944573)
○ Anchor adapter
(for self-drilling anchors)
7
955994
955995
955996
955998
PR-25B
PR-38E
956000
955154
955155
956002
955157
956004 PR-38E
955159
NOTE
A turning handle is used with this anchor adapter.
For rotation and impact
Anchor size
w1/4 (No. 20)
w5/16 (No. 25)
w3/8 (No. 30)
w1/2 (No. 40)
w5/8 (No. 50)
○ Bull point
(for crushing)
Total length 280 mm
Code No. 944566
○ Cold chisel
(for grooving and squaring)
Total length 280 mm
Code No. 944567
○ Syringe
(for removing chips after making holes)
(Code No. 944575)
○ Cutter
(for crushing asphalt)
(Code No. 955180)
○ Rammer
(for tamping sand and gravel)
(Code No. 955181)
○ Bush hammer
(for roughing concrete and stone surfaces)
(Code No. 955183)
For impact
Code No. Code No.
944593 944568
944594 944569
944595 944570
944596 944571
944597 944572
450 mm
944583
450 mm
944584