Standard Accessories; Optional Accessories (Sold Separately) - HIKOKI DH 30PC2 Instrucciones De Manejo

PRECAUTIONS ON USING ROTARY HAMMER
1. Wear ear protections
Exposure to noise can cause hearing loss.
2. Do not touch the bit during or immediately after
operation. The bit becomes very hot during operation
and could cause serious burns.
3. Before starting to break, chip or drill into a wall, fl oor or
ceiling, thoroughly confi rm that such items as electric
cables or conduits are not buried inside.
SPECIFICATIONS
Voltage (by areas)*
Power input
No-load speed
Full-load impact rate
Capacity: concrete
steel
wood
Weight (without cord and side handle)
* Be sure to check the nameplate on product as it is subject to change by areas.

STANDARD ACCESSORIES

(1) Plastic case ................................................................1
(2) Side handle ................................................................1
(3) Stopper .......................................................................1
(4) Dust cup .....................................................................1
(5) Syringe ........................................................................1
Standard accessories are subject to change without notice.

OPTIONAL ACCESSORIES (sold separately)

1. Drilling anchor holes (rotation + hammering)
○ Drill bit (Taper shank) and taper shank adapter
Drill bit (Taper shank)
Outer diameter
11.0 mm
12.3 mm
12.7 mm
14.3 mm
14.5 mm
17.5 mm
21.5 mm
(110 V, 115 V, 120 V, 127 V, 220 V, 230 V, 240 V)
Taper shank adapter
(SDS-plus shank)
Cotter
Taper mode
Morse taper (No.1)
Morse taper (No.2)
A-taper
B-taper
4. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
5. Always hold the body handle and side handle of the
power tool fi rmly. Otherwise the counterforce produced
may result in inaccurate and even dangerous operation.
6. Wear a dust mask
Do not inhale the harmful dusts generated in drilling or
chiseling operation. The dust can endanger the health
of yourself and bystanders.
850 W*
0 – 850 /min
0 – 3700 /min
4 – 30 mm
13 mm
32 mm
4.3 kg
Applicable drill bit
Drill bit (taper shank)
Drill bit (taper shank)
Taper shank adapter formed A-taper or B-taper is
provided as an optional accessory, but the drill bit
for it is not provided.
English
11.0 – 17.5 mm
21.5 mm
7