Bridge Operation; Parallel Operation - JB Systems amp 150.4 Manual De Instrucciones

ENGLISH

BRIDGE OPERATION:

Used to drive 2 channels: 2x 300Wrms @ 8Ω ~ Attention: loads below 8Ω are NOT allowed.
Using binding post outputs:
®
Using SpeakON outputs:
 Connect the audio signals to the inputs 1+3 (11/17)
 Set the operation mode switches (10/16) to "bridge"
 Connect the speakers to the outputs as shown on the drawings.
 Set input gain knobs (3/4/5/6) to zero
 Make sure there's a music signal at the left input
 Turn the amplifier on (2)
 Adjust the gain knobs (3/5) to the desired level, gain knobs (4/6) are not used.

PARALLEL OPERATION:

Used to drive 2 stereo outputs (4 channels) where mono input 1 (11) drives outputs 1+2 (13/14) and mono
input 3 (17) drives outputs 3+4 (19/20) : 4x 80Wrms @ 8Ω ~ 4x 150Wrms @ 4ohm.
Using binding post outputs:
®
Using SpeakON outputs:
 Connect the audio signals to the inputs 1+3 (11/17)
JB SYSTEMS
®
5/34
USER MANUAL
AMP 150.4