Generac 3500PSI Manual De Instrucciones página 15

Generac Portable Products 3500 PSIPressure Washer
TROUBLESHOOTING
Problem
Pump has following
problems: failure to produce
pressure, erratic pressure,
chattering, loss of pressure,
low water volume.
Detergent fails to mix with
spray.
Engine shuts down during
operation.
Cause
I. Low pressure spray tip installed.
2. Water inlet isblocked.
3. Inadequate water supply.
4. Inlet hose is kinked or leaking.
5. Clogged inlet hose strainer.
6. Water supply is over 100°F.
7. High pressure hose is blocked or
leaks.
8. Gun leaks.
9. Spray tip is obstructed.
10. Pump is faulty.
I. Detergent siphoning tube is not
submerged.
2. Chemical filter is clogged or
cracked.
3. Dirty in-line filter.
4. Low pressure spray tip installed.
Out of gasoline.
Correction
I. Replacespray tip with high pressure
spray tip.
2. Clear inlet.
3. Provide adequate water flow.
4. Straighten inlet hose, patch leak.
5. Check and clean inlet hose strainer.
6. Provide cooler water supply.
7. Clear blocks in outlet hose.
8. Replace gun.
9. Clean spray tip.
10. Contact Authorized service facility.
I. Insert detergent siphoning tube into
detergent.
2. Clean or replace fitter/detergent
siphoning tube.
3. See"Check In-LineFilter".
4. Replacespray tip with high pressure
spray tip.
Fill fuel tank.
i
15