Generac 3500PSI Manual De Instrucciones página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Generac Portable P roducts 3500 PSI P ressure Washer
Add
Engine Oil and Fuel
• Place pressure washer on a level surface.
CAUTION
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment
resulting from failure to follow this
instruction
will void warranty.
• Refer to engine owner's manual and follow oil and fuel
recommendations
and instructions.
NOTE:
Check oil often during engine break-in.
Refer to
engine owner's manual for recommendations.
Connect
Hose and Water
Supply to
Pump
IMPORTANT:
To avoid pump damage, you must
assemble the nozzle extension
to the spray gun and attach
all hoses before you start the engine.
I.
Remove and discard tape from domed oil filler cap on
top of pump.
2.
Uncoil high pressure hose and attach quick connect end
of hose to base of spray gun (Figure 2). Pull down on
collar of quick connect, slide onto spray gun and let go
of collar. Tug on hose to be sure of a tight connection.
Connect high
pressure hose
here.
NOTE:
Remove and discard all pump shipping caps before
attaching hoses.
3.
Similarly, attach other end of high pressure hose to
high pressure outlet on pump. Pull down on collar of
quick connect, slide onto pump and let go of collar.
Pull on hose to be sure of a tight connection.
4.
Before connecting garden hose to water inlet, inspect
inlet screen (Figure 3). Clean screen if it contains
debris, replace if damaged. DO NOT RUN PRESSURE
WASHER IF SCREEN IS DAMAGED.
use if damaged;
clean if dirty.
5.
Run water through garden hose for 30 seconds to
clean out any debris. Turn off water.
IMPORTANT:
DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
6.
Connect garden hose (not to exceed 50 feet in length)
to water inlet.Tighten
by hand (Figure 3).
CAUTION
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
7.
Turn ON water and squeeze trigger on spray gun to
purge pump system of air and impurities.
WARNING
Always wear eye protection
when using this equipment
or in
vicinity of where equipment
is in use.
Before starting the pressure washer, be sure you are wearing
adequate eye protection.
Checklist
Before
Starting
Engine
Review the unit's assembly to confirm you have performed
all of the following:
I.
Make sure handle is in place and secure.
2.
Check that oil has been added to proper level in
engine crankcase.
3.
Add proper fuel to fuel tank.
4.
Check for properly
attached hose connections.
/
7

Publicidad

Tabla de contenido
loading

Tabla de contenido