Visual Signals (Led) - Reiner jetStamp graphic 970 Manual De Instrucciones

jetStamp graphic 970

4.3. Visual Signals (LED)

When the indicator flashes orange (warning), the status display
of the PCset graphic software shows a detailed device message
(see „Operating Interface" Page 49).
LED indicator Condition
Green
Green Flashing
Orange Flashing,
(warning) interval of 1
Orange Flashing,
(warning) Interval of 2
Orange Flashing,
(warning) Interval of 3
Orange Flashing,
(warning) Interval of 4
Orange Flashing,
(warning) Interval of 5
Red Flashing,
(error) interval of 1
Cause Removal
Ready
- Device is in - Switch off and
standby mode on again or push
trigger button
- No or defective - Insert print
print cartridge cartridge
- Wrong print
cartridge
- Ink level writing
error
- Print cartridge - Insert print cart-
not inserted ridge correctly
correctly - Charge recharge-
- Rechargeable able battery
battery empty - Insert/replace
- No rechargeable rechargeable
battery/defecti- battery
ve rechargeable
battery
- Print carriage
movement
blocked
- Print cartridge - Check print
almost empty
- Print cartridge - Replace print
empty cartridge
- jetStamp graphic - Put the jetStamp
970 not in the graphic 970 in
base station the base station
- Battery nearly - Charge/replace
flat/capacity low rechargeable
battery
- Device error - Disconnect
device from the
power supply for
approx. 3 seconds
(including
rechargeable bat-
teries and USB
connection)
d
g
Notes
- Power saving mode
1
- The detailed cause
and removal can be
determined in the
d
status display
the PCSet graphic
software
- Acoustic signal as
well
- Acoustic signal as
well
- The display appears
after 30 seconds wit-
hout use for standard
ink, and after 10
seconds for MP ink.
- Acoustic signal as
well
- Acoustic signal as
well
- If the error remains
after activation,
have the device
inspected by the
REINER support
of
GB
63