WAGNER Pole Gun Manual De Usuario página 15

Operation
1. Make sure the arrow on the tip handle is pointing in the forward direction for spraying.
2. Start the sprayer. Refer to the instructions in the sprayer's Owner's Manual.
3. Adjust the fluid pressure on the sprayer until the spray is completely atomized. Always spray
at the lowest pressure necessary to get the desired results.
i
The spray tip determines the size of spray pattern and coverage. When more
coverage is needed, use a larger tip instead of increasing fluid pressure.
4. Operate the trigger and use the same spraying techniques as with standard pistol-grip airless
spray guns.
Use extreme caution when spraying with a
extension pole. Do not spray near power
lines. Avoid all other over-head obstacles.
5. To clear a clogged tip:
a. Rotate the tip 180º so that the arrow on the tip handle is pointing opposite the spray
direction.
b. Trigger the gun once so that the pressure can blow the clog out.
Never pull the trigger more than once at
time with the tip in the reverse position.
Attention
c. Continue this procedure until the tip is clear of the clog.
Changing a Tip
Tips can be removed and replaced easily without disassembling the gun.
Never attempt to change or clean the tip or tip guard without first performing the
"Pressure Relief Procedure."
1. Perform the "Pressure Relief Procedure" described in the sprayer's Owner's Manual.
2. Remove the tip from the slot on the tip guard.
3. Insert the new tip into the slot on the tip guard. The arrow on the tip handle should be pointing
in the forward direction for spraying.
Removing the Tip Seal and Tip Seal Retainer
1. Remove the tip and tip guard from the spray gun.
2. Insert the tip handle through the front of the tip guard.
3. Push the tip seal and tip seal retainer out through the back of
the tip guard.
Identifying Tip Sizes
To identify tip sizes, use the following formula. A "517" tip size will be
used in this example.
The first digit multiplied by two represents the size of the spray
pattern when spraying 12" away from the work surface:
5 x 2 = 10" spray pattern
The second two digits represent the diameter of the orifice on the tip:
17 = .017" orifice
i
Worn spray tips will adversely affect the spray pattern and result in reduced
production, poor finish, and wasted material. Replace worn tips immediately.
Pole Gun
GB
Tip Seal
Tip Seal
Retainer
Tip
Guard
Tip
15