Ferroli VARESE Serie Manual Técnico Y De Instalacion página 35

• Using a small rubber hammer, open the holes in the co-ver enough to place the
inlets on the desired side and place the cover over the previously prepared holes
• Connect the one-pipe keys and thermostatic valve. With one-pipe installa-
tions, the use of valves with a curve for the upper hot water inlet is required.
• When water begins
per bleeder to remove
• Assemble the front panel. On models with HE system, replace the cover
plugs in the front holes.
to fill the radiator,
air inside the heat
Unit installation
use the up-
exchanger .
Fig. 24 Fig. 25
Fig. 26
Fig. 27
35