He System Connection - Ferroli VARESE Serie Manual Técnico Y De Instalacion

HE SYSTEM CONNECTION

Models equipped with the HE system come pre-installed for the water inlet sockets on the right-hand side. If your installation requires inlet sockets on the left
side, follow these points by order. Otherwise, skip to point 4:
1. Before mounting the core on the wall remove the four screws that support the fan HE KIT
at the top (fig. 35).
2. Also remove the ambient sensor support by removing its two screws (fig. 35).
3. Turn the heat exchanger around by 180º and position again the HE KIT and the ambient
sensor in the same position, as is shown in figs. 36
4. Attach the clip of the water detection sensor to the tubes as is shown in figs. 37 and 38,
taking into account the position of the water inlet sockets to the right (fig 37) or left (fig. 38).
5. Connect the HE KIT fan power cord. (fig 39).
6. Connect the room temperature sensor: Fig. 40
7. Plug in the power cord into 220/230v A.C. 50 Hz . The emitter is provided with an open
cable gland so that the cable can be removed and be plugged into an outlet socket that is
inside the cover (check current regulations).
38
Unit installation
Fig. 37
Fig. 38
Fig. 40
Fig. 35
Fig. 36
Fig. 39