STERWINS 320 EP-2 Manual De Instrucciones página 144

8). Providing your lawn mower with regular care will not only extend its life and
performance but also help you to mow your lawn mower properly and easily.
9). Clean the lawn mower with a brush or cloth. Do not use any solvents or water
to remove dirt.
10). The component that is subject to most wear is the blade. You should therefore
check the condition of the blade and its mounting at regular intervals.
- If the blade is worn or blunt it must be replaced or ground immediately;
- If the lawn mower starts to suffer from excessive vibrations, this means that
the blade has not been balanced correctly or has suffered deformation due to
impacts. In this case it must be repaired or replaced.
11). Keep all nuts, bolts, and screws tight to be sure the appliance is in safe working
condition.
12). Check the grass catcher frequently for wear or deterioration.
13). Replace worn or damaged parts for safety.
14). For rotary mowers, ensure that only replacement cutting means of the right type
are used.
15). Be careful during adjustment of the machine to prevent entrapment of the
fingers between moving blades and fixed parts of the machine.
16). Always allow the machine to cool down before storing.
17). When servicing the blades be aware that, even through the power source is
switched off, the blades can still be moved.
18). Replace worn or damaged parts for safety. Use only genuine replacement parts
and accessories.
2. Replacing the blade.
WARNING! For safety reasons, we recommend having the blade
replaced by an authorized professional. Never carry out any
assembly operations or adjustments with the power connected
to the mower. Always ensure that the power button is in the off
position and that the power plug is disconnected from the supply.
Always handle the blade with gloves for care-sharp edges could
cause injury.
Carry out the following steps to change the blade:
- Undo the fastening screw.
- Remove the blade and replace with a new one.
- When fitting the blade, make sure it is installed in the right direction. The blade's
air vanes must jut into the motor compartment.
brushes should not be rep laced by anyone but a qualified electrician.
3. Maintenance.
There are no parts inside the equipment which require additional maintenance.
4. Ordering replacement parts.
Please quote the following data when ordering replacement parts:
- Type of machine
- Article number of the machine
- Identification number of the machine
- Replacement part number of the part required
EN - 19