1. SPECIFICATIONS OF THE APPLIANCE
Voltage: 230 V ~ 50 Hz
GB
Insulation class: II
Protection class: IP34
Power [W]
Rated current [A]
The radiator's technical specifications are indicated
on the rating plate on the bottom right of the radia-
tor (Fig. 1).
A Brand/Manufacturer
B Model, type, category
C Voltage and Power
D Double insulation
E Country of origin
F CE marking
2. GENERAL INFORMATION
Storage and maintenance:
Avoid storing the appliance in places at risk of
freezing. Protect from frost.
Unpack the appliance carefully and rest it on the
polystyrene corner pieces or a carpet.
The package contains:
– the appliance
– mounting kit
– instructions
Read all the instructions carefully before installation
and use. Keep for future consultation.
Install and use the appliance as described in these
instructions only.
These instructions do not cover all situations which
might arise. Caution and common sense should be
applied when installing, operating and servicing
the appliance.
200
300
400
500
0.9
1.3
1.8
2.2
G Serial Number
H Product Code
I
Protection class
L Quality marks
M Disposal procedures
N Bidimensional Code
(QR)
600
700
750
900
2.6
3
3.3
4
Modifying the characteristics of the appliance and
removing any fixed component including the caps
and/or removing or rotating the control device in any
way are expressly prohibited (Fig. 2).
Make sure the appliance is complete and undam-
aged. If damaged, do not use the appliance, but con-
tact your local dealer or a qualified professional.
The materials used for packaging can be recycled.
You are therefore recommended to dispose of them
in special differentiated waste collection containers.
3. POSITIONING AND INSTALLING
The appliance is designed to heat domestic rooms
or similar. It must not be used for other purposes.
The appliance must be used permanently mounted
on a wall as described in the instructions.
Install the appliance with the control device at
the bottom right and the control keys towards the
front as in Fig. 3.
In bathrooms (with bath or shower), install the ap-
pliance outside zone 1.
The appliance must be installed in such a way that
the electronic controls and other control devices
may not be touched by someone in the bath or
shower. The appliance must not be connected with
a plug.
For radiators already fitted with power
plugs, see the warnings on page 24.
Respect the distances shown in figures 4,5.
Never install the appliance:
– immediately below or in front of a power socket or
a junction box (Fig. 6)
– in contact with the wall or floor
– near curtains, flammable or combustible materials
or pressure vessels.
14
1000 1250 1400 1500 2000
4.5
5.5
6
6.5
Table 1
9