Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
DESCRIPTION
A
Power indicator light
B
ON/OFF button
C
+/- adjustment buttons
D
MODE button (selects the operating mode)
E
"ECO plus" button
F
Timer button
G
handle
H
air outlet grill
General instructions
Remove the appliance from the packaging.
Check that neither the appliance nor the power cable has
been damaged during transport. Do not operate the heater if
damaged. Remove all publicity material from the appliance.
The appliance is suitable for free-standing or wall-mounted
usage. Feet must be removed before wall mounting.
Electrical connection
-
Before connecting the appliance to the power socket,
check that the voltage indicated on the appliance rating
plate is the same as your electrical system and that it can
support the power consumption (wattage) indicated.
-
If more than one appliance is used at the same time, it is
important to ensure that the electrical system is able to
support the power required.
Use on the floor
Turn the radiator upside-down on a rug or a soft surface in
order to prevent damaging the paint finish. Rotate the feet
as shown in figure 2 in order to put the feet in position.
Turn the radiator back to its upright position.
See Figure 3 for the minimum distances of the appliance
from the walls.
Important! Use this heater on a flat hard floor.
Important! never use the appliance without feet if it is
not mounted on the wall.
Important! when using the appliance, position the
feet as shown in figure 2 only.
Installation on the wall
The kit for wall installation contains:
2 metal brackets for mounting - upper support (J)
2 metal brackets for mounting - lower support (K)
2 butterfly screws M5 (L)
4 screws 4.5 x 25 PH (M)
4 plastic wall anchors 6 x 30 (N)
Tools required for wall mount installation
Drill
Screwdriver PH 2x100 (phillips head)
Estimated time for installation: 30 minutes
Before installing the unit, ensure the following:
a. The device must not be placed directly under a
power socket.
b. The plug and power socket must be easy to reach
after installation.
c. No electric cables or other pipework could be
damaged during installation.
d. Keep away from curtains or flammable materials.
Do not install the appliance on flammable walls.
For wall mounting, proceed as follows:
Turn the appliance upside down on a flat and stable surface.
Press the "PUSH" button on the bottom of the foot to allow
it to rotate to its original position as shown in figure 4 and
expose the screw.
Remove the screw as shown in figure 5 to unhook the feet from
the appliance as shown in figure 6.
Fix the two brackets K with the two butterfly screws L as
shown in Fig. 8.
1. Before drilling the wall, mark the exact spot, respecting
the minimum distances as shown in Fig. 7.
2. Drill following the marks that you have made and insert
the wall plugs N. For brick walls use a masonry bit
of 6 mm. For plasterboard or false walls (empty), we
recommend the use of appropriate screws and anchors
(not supplied).
3. Fix the 2 metal brackets J to the wall using the screws M
provided.
4. Hang the appliance on the brackets.
5. Mark the lower fixing points corresponding to the holes
of the brackets K. Remove the appliance, drill the lower
holes and insert the wall plugs N.
6.
Now you can hang the unit on the brackets and secure the
bottom of the appliance with the 2 screws M remaining.
USE
Operation and use
-
Plug into the outlet socket.
-
The appliance emits a beep. The power indicator light
(A) comes on and remains lit while the appliance is
powered.
-
The appliance switches to standby.
-
Press the ON/OFF (B) to turn the appliance on. It begins
6
Publicidad
Tabla de contenido
