General Information; Wall Mounting - DeLonghi FIVY VERTICAL ELETTRICO Manual De Instrucciones Para El Uso

1. SPECIFICATIONS OF THE APPLIANCE
Voltage: 230 V ~ 50 Hz
Insulation class: II
GB
Protection class: IP24
Power Length
[W] [cm]
1000 57
1500 57
1750 57
Table 1
on the rating plate on the bottom right of the radia-
tor (Fig. 1).
A Brand/Manufacturer
B Model, type, category
C Voltage and Power
D Double insulation
E Country of origin
F CE marking

2. GENERAL INFORMATION

Unpack the appliance carefully and rest it on the
polystyrene corner pieces or a carpet.
The package contains:
– the appliance
– remote control with two batteries and container
for wall mouting
– mounting kit
– instructions
Read all the instructions carefully before installation
and use. Keep for future consultation.
Install and use the appliance as described in these
instructions only.
These instructions do not cover all situations which
might arise. Caution and common sense should be
applied when installing, operating and servicing the
appliance.
Modifying the characteristics of the appliance and
expressly prohibited.
Make sure the appliance is complete and undamaged.
If damaged, do not use the appliance, but contact
Height Weight Rated
[cm] [kg] current [A]
148 37 4,5
178 45 6,5
202 53 7,6
G Serial Number
H Product Code
I Protection class
L Quality marks
M Disposal procedures
N Bidimensional Code
(QR)
The materials used for packaging can be recycled.
You are therefore recommended to dispose of them
in special differentiated waste collection containers.
3. POSITIONING AND INSTALLING
The appliance is designed to heat domestic rooms
or similar. It must not be used for other purposes.
The appliance must be used permanently mounted on
a wall as described in the instructions.
Install the appliance with the control panel at the
bottom (Fig. 2).
In bathrooms (with bath or shower), install the
appliance outside zone 1.
The appliance must be installed in such a way that
the electronic controls and other control devices
may not be touched by someone in the bath or
shower. The appliance must not be connected with
a plug.
For radiators already fitted with power
plugs, see the warnings on page 24.
Never install the appliance:
– immediately below or in front of a power socket or
a junction box (Fig. 5)
–
–
or pressure vessels.
Make sure there are no pipes or electric wires in the
wall which could be damaged while mounting the
appliance.
The appliance is equipped with a sensor which can
detect an open window, if present in the proximity of
the radiator. For a proper operation, it is strongly rec-
ommended to comply to the installation directions
reported in Ch. 4.5.1. before wall mounting.

3.1 WALL MOUNTING

Make sure the screws and anchors included in the
mounting pack are suitable for the type of wall on
which you are mounting the appliance. If in doubt,
14