Antenna Connection - JVC LT-22HG32U Manual De Instrucciones

Antenna connection

Note: Before you connect other appliances:
• To avoid potentially damaging your set, make sure all items are switched off and disconnected from the
mains power when you make the connections.
• Arrange the desired connection.
• When you have finished making the connections, reconnect the mains power to the unit and switch it
back on.
Connect your antenna as shown below (A). Connections to other equipment is explained further on
P.24-25. If you have problems with reception, consult a specialist of antenna.
Back Side
LT-22...
(H)
(I)
(J)
M4 x 10
(K)
LT-24...
(H)
(I)
(J)
(N)
(K)
(L) Bracket holes: Fix a wall mounting bracket (not supplied) here.
(M) To hang the television on a wall, remove these screws and then remove the stand.
Before performing work spread cushioning over an area to lay the TV on.
(N) Service connector cover: Please do not open this cover. There is a socket only for service purpose inside.
10
100 mm
100 mm
(L)
(M) (N)
M4 x 10
100 mm
(L)
100 mm
(M) (N)
(A) Antenna: Connect an antenna.
The built-in tuner receives all
analogue cable programmes
(A) and DVB-T/-C channels.
(B) DIGITAL AUDIO COAXIAL
(B)
output: digital audio output
(C) AV/COMPONENT input:
Input for analogue AV-Signal/
(C)
Component-Signal. See P.24,
(D)
25
Note: AV-AUDIO input is
sharing with COMPONENT
AUDIO input.
(E)
(D) USB input: See P.22-23.
(E) Scart socket: For the
(F)
connection of scart cable. See
P.25.
(G)
(F) C.I. slot: for CA- module
(CAM) (if PayTV-provider
supports this).
Note: To prevent malfunctions
and damages, be sure to turn
off the TV before inserting or
(A)
removing the CAM card.
(G) HEADPHONE jack: Plug
(B)
headphones with a mini plug
(3.5 mm) into this jack.
(C) (H) PC-INPUT (PC): See P.24.
(D)
(I) PC/DVI AUDIO input: See
P.24.
(J) HDMI/DVI input: See P.24.
(K) Power supply: Connect the
(E)
supplied power cable to an AC
220-240V/50Hz mains power
supply only - do not attempt
(F)
to connect it to any other type
of supply. Never try to repair a
(G)
damaged AC power cord with
isolation-tape - this should
be repaired by a specialist or
replaced. Do not let your pet
loose near the cable. Animals
biting into the cable could
receive a fatal electric shock,
and could cause a hazard to
others.