Sony CDP-LSA1 Manual De Instrucciones página 2

WARNING
To prevent fire or shock
hazard, do not expose the unit
to rain or moisture.
To avoid electrical shock, do
not open the cabinet. Refer
servicing to qualified
personnel only.
The laser component in this product
is capable of emitting radiation
exceeding the limit for Class 1.
This appliance is classified as a CLASS 1
LASER product.
The CLASS 1 LASER PRODUCT
MARKING is located on the rear
exterior.
The following caution label is located
inside the unit.
GB
2
Precautions
On safety
• Caution — The use of optical
instruments with this product will
increase eye hazard.
• Should any solid object or liquid fall
into the cabinet, unplug the player and
have it checked by qualified personnel
before operating it any further.
On power sources
• The unit is not disconnected from the
AC power source (mains) as long as it
is connected to the wall outlet, even if
the unit itself has been turned off.
• If you are not going to use the player
for a long time, be sure to disconnect
the player from the wall outlet. To
disconnect the AC power cord (mains
lead), grasp the plug itself; never pull
the cord.
• AC power cord must be changed only
at the qualified service shop.
On placement
• Place the player in a location with
adequate ventilation to prevent heat
build-up in the player.
• Do not place the player on a soft
surface such as a rug that might block
the ventilation holes on the bottom.
• Do not place the player in a location
near heat sources, or in a place subject
to direct sunlight, excessive dust or
mechanical shock.
On operation
If the player is brought directly from a
cold to a warm location, or is placed in a
very damp room, moisture may
condense on the lenses inside the player.
Don't throw a
Should this occur, the player may not
battery, dispose it as
operate properly. In this case, remove
the injurious wastes.
the disc and leave the player turned on
for about an hour until the moisture
evaporates.
On adjusting the volume
Do not turn up the volume while
listening to a portion with very low level
inputs or no audio signals. If you do, the
speakers may be damaged when a peak
level portion is played.
On cleaning
Clean the cabinet, panel and controls
with a soft cloth slightly moistened with
a mild detergent solution. Do not use
any type of abrasive pad, scouring
powder or solvent such as alcohol or
benzine.
Replacing the battery in the remote
Slide out and remove the battery case
and insert a new lithium battery CR2025
with the + side facing up. And then,
slide the battery case back in.
A lithium battery CR2025
1
2
1 Keep pushing
2 Pull out
CAUTION
Danger of explosion if battery is
incorrectly replaced. Replace the battery
only with the same or eqivalent type
recommended by the manufacturer.
Discard used batteries according to the
manufacturer's instructions.
On transport
When transporting the player, be sure to
attach the protective bar onto the disc
tray, and secure it with adhesive tape as
it was at the time you purchased the
player. For details about attaching the
protective bar, see page 5.
Before transporting the player, be sure to
remove any CD that may be loaded.
If you have any questions or
problems concerning your player,
please consult your nearest Sony
dealer.