Getting Started; Unpacking; Hooking Up The System - Sony CDP-LSA1 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Getting Started

Getting Started

Unpacking

Check that you have received the following items:
• i.LINK connecting cable (1)
• Remote commander (remote) (1)
Before using the supplied remote
The supplied remote already contains a battery. Before
using the remote, pull out the insulating sheet to allow
the power to flow from the battery.
To avoid battery leakage
If you don't use the remote for an extended period of time,
remove the battery to avoid possible damage from battery
leakage and corrosion.
z
When to replace the battery
Under normal conditions, the battery should last for
about six months. When the remote no longer operates
the player, replace the battery with a new one.
Notes on lithium battery
• Keep the lithium battery out of the reach of the children.
Should the battery be swallowed, immediately consult a
doctor.
• Wipe the battery with a dry cloth to assure a good contact.
• Be sure to observe the correct polarity when inserting the
battery.
• Do not hold the battery with metallic tweezers, otherwise a
short-circuit may occur.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble, or dispose of in fire.
GB
4

Hooking Up the System

Overview
This section describes how to hook up the CD player to
a receiver or other components such as an MD deck.
Be sure to turn off the power to all components before
you start connecting them.
CDP-LSA1
v
v
i.LINK
S200
Receiver*
:
Signal flow
ç
* You can connect components to either i.LINK S200
connector.
What cords will I need?
i.LINK connecting cable (supplied) (1)
b
To a mains
i.LINK
S200
MD deck, etc.*

Publicidad

Tabla de contenido
loading

Tabla de contenido